Jumper And Switch Settings - Daikin FLXS-BAVMB Service Manual

SiBE05-722_B
4. Cutting jumper sets the indoor fan tap to the highest position.
4.4

Jumper and Switch Settings

JB
(on indoor unit PCB)
JC
(on indoor unit PCB)
J5
(on outdoor unit
PCB)
<Floor / Ceiling Suspended Dual Type>
SW2
(on indoor unit PCB)
For the location of the jumper and the switch, refer to the following pages.
Indoor unit; page 16
Outdoor unit; page 18, 20, 22
Trial Operation and Field Settings
A humidifier might cause dew jumping from the indoor unit outlet vent.
Jumper Function
Fan speed setting
when compressor
stops for thermostat
OFF.
(effective only at
cooling operation)
Power failure
recovery function
Improvement of
defrost performance
Switch Function
Installation style
changeover
When connected
(factory set)
Fan speed setting; Fan rpm is set to "0"
Remote controller <Fan stop>
setting
Auto-restart The unit does not resume
operation after recovering from
a power failure. Timer ON/OFF
settings are cleared.
Standard control Reinforced control
(ex. The frequency increases,
the duration time of defrost
lengthens.)
FLOOR
(factory set)
When installed as When installed as the ceiling
the floor mounted suspended type
type
Field Settings
When cut
CEILING
218