Belkin F1DD102U Quick Installation Manual page 3

Introduction
This booklet is a quick guide through the basic steps needed to
install the SOHO Series KVM Switch with Audio (the KVM Switch). If
you have any problems during installation, please refer to the KVM
Switch User Manual.
You will need the following items to install the KVM Switch:
• SOHO Series KVM Switch with Audio
• One (each) USB keyboard, DVI monitor, and USB mouse
• One DVI and USB KVM cable per computer installed
• One 9V DC, 1A power supply adapter
• Optional—audio cables (3.5mm plugs) for speakers and
microphone installation
Recommended Cable Kits:
F1D9201-XX KVM Cables for SOHO Series DVI with Audio,
USB Style
(-XX denotes the length of cable in 6, 10, and 15 feet)
Installing the KVM Switch Base
Connecting the Video, Keyboard, and Mouse to the
1
CONSOLE Ports and Computers on the KVM Switch
1. Power down your computers.
2. Remove the rear panel of the KVM Switch to expose the ports. (Fig. 1)
2nd computer
DVI port–DVI 2
2nd computer
USB mouse/keyboard
ports
1st computer
USB mouse/keyboard
ports
CONSOLE USB
mouse/keyboard
ports
CONSOLE
DVI port
Flash-upgrade port
2nd computer
audio/microphone jacks
1st computer
audio/microphone jacks
1st computer
DVI port–DVI 1
CONSOLE
audio/
microphone
jacks
USB input
ports—
devices 1
and 2
DC power jack
Base
Fig. 1