Technical Data - Hilti TE 4-A22 Operating Instructions Manual

LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
en
NOTE
Indication of the charge status is not possible while the power tool is in operation or immediately after operation. If the
battery charge status LEDs blink, please refer to the information given in section 9.

4 Technical data

Right of technical changes reserved.
Power tool
Rated voltage (DC voltage)
Weight in accordance with EPTA procedure 01/2003
Rated speed under no load n₀
Single impact energy in accordance with EPTA proced-
ure 05/2009
Drilling diameter range in concrete/masonry (hammer
drilling)
Drilling diameter range in wood module-head bit)
Drilling diameter range in wood (auger bit)
Drilling diameter range in metal module metal)
NOTE
The vibration emission level given in this information sheet has been measured in accordance with a standardised test
given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment
of exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is
used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total working period. An estimation of the level of exposure to
vibration should also take into account the times when the tool is switched off or when it is running but not actually
doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety
measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Noise and vibration information (measured in accordance with EN 60745‑2‑6):
Typical A-weighted sound power level, L
Typical A-weighted emission sound pressure level., L
Uncertainty for the given sound level, K
Triaxial vibration values (vibration vector sum)
Hammer drilling in concrete, a
Drilling in metal, a
Uncertainty (K) for triaxial vibration values
NOTE
With the B22/1.6Ah battery, performance of the tool is reduced.
14
LEDs blink
-
-
-
-
LED 1
WA
h, HD
h, D
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
TE 4‑A22
21.6 V
3.3 kg
1,090/min
2.0 J
5...16 mm
3...20 mm
Max. 14 mm
3...10 mm
99 dB (A)
88 dB (A)
pA
3 dB (A)
measured in accordance with EN 60745‑2‑6
11 m/s²
5.5 m/s²
1.5 m/s²