Printing Or Copying Problems - Epson stylus CX4100 series User Manual

■
Turn off the Stylus CX, then make sure the ink cartridges are inserted completely
and the ink cartridge cover is closed completely. Also make sure no packing
material remains in the Stylus CX. Wait a moment, then turn the Stylus CX back
on to clear the error.
You're having problems installing the Stylus CX software.
■
Make sure your Stylus CX is turned on and the USB cable is securely connected at
both ends. Then carefully follow the installation instructions on the Start Here
sheet. Also make sure your system meets the requirements listed in System
Requirements.
■
Close your other programs, including any screen savers and virus protection
software, and install the software again.
■
In Windows, make sure the Stylus CX is selected as the default printer and that
the correct port is shown in the printer properties.
■
If you're using Windows 2000 and you see an error message or your software
doesn't install correctly, you may not have software installation privileges. Contact
your System Administrator.
■
If you're using Windows and the USB port, make sure your system was not
upgraded from Windows 95. The USB Printer Device Driver may not install
correctly.
■
Make sure the USB Controller is working properly in Device Manager. See your
Windows help system for details. If it's not working, contact your computer
manufacturer.
■
If you're printing over a network, see Setting Up Network Printing for
instructions.

Printing or Copying Problems

Only the green
■
Make sure the USB cable is connected securely at both ends and meets the
requirements listed in System Requirements.
■
Run a printer check. If the test page prints, make sure your software is installed
correctly.
On light is on, but nothing prints.
96