Casio MD-910 Technical Manual page 24

(13) Mount the paper pressure guide on the
back of the frame assembly.
(14) Set the PF clutch spring and the clutch
spacer in the clutch gear of the paper
feed and then put it in the frame as-
sembly from over the paper pressure
guide.
Note:
1) The clutch spacer must be set from
the right of the frame assembly to
the inside.
Therefore, set it while the PF clutch
spring is shortened.
2) When assembling, align the protru-
sions on the bottom of the paper
feed bracket with the holes of the
frame assembly.
(15) Secure both the paper feed and the
paper pressure guide to the frame as-
sembly with two screws (M2 × 2.5).
(16) Apply Froil G-311S to the pivot of the
ribbon drive and the teeth of the sec-
tor gear assembly.
(17) Insert the sector gear assembly in the
pivot of the ribbon drive.
Note: When inserting the assembly,
engage the bottom teeth of the
sector gear assembly with the
final gear of the clutch gear.
— 21 —