Navman Tracker 5380 Installation And Operation Manual page 17

Going to a point on the chart
1 Switch to a chart display.
2 Move the cursor to the destination point:
either use the cursor keys or use Find (see
section 3-2-5).
3 Press and select Goto cursor.
Warning: Make sure the course does not
pass over land or dangerous waters.
Tip: Before starting, create waypoints at points of interest. Create a waypoint at the start of the
trip for you to navigate back to (see section 5-2-1).
3-1-3 Following a route
Preparing
A route is a list of waypoints that the boat can
follow (see section 6).
To create waypoints before creating the
route, see section 5-2-1.
To create a route, see section 6-2-1.
Starting a route from the chart display:
1 Go to the chart display.
2. Press and select Start Route.
3. Press or to highlight the route to
follow. Press
4. The TRACKER asks for the direction to
traverse the route.
Select Forward (the order the route was
created) or Reverse .
5. The TRACKER displays the chart with the
route marked and starts navigating from
the start of the route.
Starting a route from the routes display:
1 Go to the routes display.
2 Press or to highlight the route to
follow. Press
3 The TRACKER asks for the direction to
traverse the route.
Select Forward (the order the route was
created) or Reverse.
TRACKER 5380 Installation and Operation Manual
.
and select Start.
Navigating
The TRACKER navigates to the point as
described in section 3-1-1.
Cancelling navigating
Go to a Chart display, press
Cancel goto.
4 The TRACKER displays a chart with the
route marked and starts navigating from
the start of the route.
Navigating
The TRACKER navigates to each waypoint on
the route in turn as described in section 3-1-1.
The TRACKER stops navigating to the waypoint
at the end of the current leg and starts the next
leg of the route:
a when the boat comes within 0.025 nm of
the waypoint
b or when the boat passes the waypoint
c or if you skip the waypoint.
Skipping a waypoint
To skip a waypoint, go to a chart display, press
and select Skip . The TRACKER starts
navigating straight towards the next waypoint
on the route.
Warning: Skipping a waypoint with the
autopilot on might result in a sudden course
change.
Cancelling a route
When the boat has reached the final waypoint,
or to stop the boat following the route at any
time, cancel the route. Go to a chart display,
press
NAVMAN
and select Cancel route.
and select
17