Sharp UX-A760 Operation Manual page 30

Using TEL Mode
Answering a call on a phone
connected to the same line
Note: To ensure correct operation of
this feature, the Fax Remote Reception
setting must be set to YES (see page
28).
1
Answer the phone when it rings.
2
If you hear a soft fax tone, wait until
the machine responds (the phone
will go dead), then hang up.
3
If the machine doesn't respond, or if
the other party first talks to you and
then wants to send a fax, press
once and
phone (only on a tone dial phone).
This signals the machine to begin
reception. Hang up.
(You can also start fax reception by
setting down the phone without
hanging up, walking over to the
machine, and pressing
•
Step 3 is necessary if you have set
the Fax Signal Receive setting to NO
(page 29).
28
twice on the
START
.)
Putting a call on hold
To put the other party on hold during a
phone call, press
UX-A760). When this is done, they
cannot hear you. You can put the
handset back in the cradle without
breaking the connection. When you are
ready to speak with the other party
again, pick up the handset. If you did
not put the handset back in the cradle,
press again to resume
conversation.
Fax Remote Reception setting
If you want ensure that the machine is
always able to start fax reception when
you press ,
extension phone, set this function to
YES (this keeps the machine from
entering sleep mode).
Initial setting: NO
1 F
Press ,
2
Press (YES) to turn on fax
remote reception (disable sleep
mode).
Press (NO) to turn off fax
remote reception.
3
Press
( on the
, on an
, , and .
to exit.