Automatic Bilge Panel - CORRECT CRAFT Nautique 220 Owner's Manual

Section 4
The purpose of the battery selector switch is to keep one as a spare.
If both batteries are ON and one battery is used to start your
engine, and the other for accessories, both batteries will become
discharged. This will eliminate your spare and could leave you
stranded.
Make sure the battery connections stay clean and secure.

Automatic Bilge Panel

Bilge Pump Only Mode - This feature is activated by a switch located
on the side console. The switch has three positions, ON, OFF and
BILGE. If the boat is going to sit for more than a few days with the
bilge pumps on, it is important the switch is set in the BILGE
position to minimize battery drain. This will activate the bilge pump
and shut off power to the Serial Switching and Keyless Ignition
System. It is important to remember the engine or other accessories
can not be used unless the switch is in the ON position.
Bilge
A circuit breaker and indicator light is located with the switch for
the bilge pump. The circuit breaker is only active when the switch
is in the BILGE position. The indicator light will come on anytime
the bilge pump is activated.
4-44
Pump
Indicator
Bilge Pump On
NOTICE
All On
Pump
All Off
Circuit
Breaker
Bilge
CORC024
Correct Craft, Inc.