Automatic Bilge Panel - CORRECT CRAFT 210 Owner's Manual

V-Drive Sec 4_2010.qxp:Naut Air Sec 4.qxd
Section 4

Automatic Bilge Panel

Bilge Pump Only Mode - This feature is activated by a switch located
on the side console. The switch has three positions, ON, OFF and
BILGE. If the boat is going to sit for more than a few days with the
bilge pumps on, it is important the switch is set in the BILGE
position to minimize battery drain. This will activate the bilge pump
and shut off power to the Serial Switching and Keyless Ignition
System. It is important to remember the engine or other accessories
can not be used unless the switch is in the ON position.
An indicator light is located with the switch for the bilge pump. The
indicator light will come on anytime the bilge pump is activated. If
your panel has a circuit breaker, the circuit breaker is only active
when the switch is in the BILGE position.
4-38
All On
Bilge
All Off
Pump
Indicator
Bilge Pump On
7/22/09 1:44 PM Page 38
Bilge
Pump
Circuit
Breaker
CORC024
CORC202