Gauges - CORRECT CRAFT Nautique 220 Owner's Manual

Erasing the User Codes
Make sure the system indicator light is OFF.
Enter the Master Embedded Code, press and release the 1/2 key
and the 7/8 key at the same time to erase the system user codes.
The keyless ignition will now act as if there are no codes in memory.
Pressing the START key will unlock the system and pressing the
STOP key will lock it without entering a code. Follow the steps in
"Programming The Primary User Code" in this section.

Gauges

The optional dash pod uses the Faria
receives information from the engine ECU and various individual
sensors throughout the boat. This information is transformed into
digital data, which is distributed to analog and digital instruments
via a single cable consisting of two shielded, twisted pairs of
conductors.
Each instrument selects the data, which applies and displays it as if
it was received from the sender directly. One of the two pairs of
conductors carries the data while the other pair of conductors
carries the power for the instruments. The tachometer and
speedometer each have three pushbuttons, which allow the
different functions of each instrument to be activated.
Controls and Indicators
Down
Button
® Serial Bus
Mode
M
Button
Up
Button
CORC113
TM system which
4-21