2-16.STROBOSCOPE SECTION
1 Screw (M1.7 × 2.5),
lock ace, p2 (black)
2-17.FP-707 BOARD
4 Screw (M1.7 × 2.5),
lock ace, p2 (silver)
Caution
The power capacitor of the flash unit is charged up to 300 V maximum. If you touch
the capacitor terminal that is charged to high voltage, you will receive an electric
shock. This high voltage is not discharged even if you turned off the main power
of this set, and it residues. Discharge the residual voltage referring to the service
note (page 1-2).
Caution
The power capacitor of the flash unit is charged up to 300 V maximum. If you touch
the capacitor terminal that is charged to high voltage, you will receive an electric
shock. This high voltage is not discharged even if you turned off the main power
of this set, and it residues. Discharge the residual voltage referring to the service
note (page 1-2).
2 Remove the
two solderings
3 Elect 80MF cap
1 Condenser insulating sheet
7 Stroboscope luminous
unit (ST5000) (24P)
2-13
DCR-PC330/PC330E
3 Stroboscope section
2 Three tapping screws
(M1.7 × 3.5) (silver)
8 ST insulating sheet
6 Make the FP-707
board inside-out.
5 Two claws
9 FP-707 board