Flush Glass Installation; Safety Screen Installation / Removal - Regency E21-NG10 Owners & Installation Manual

FLUSH GLASS
INSTALLATION
1) Install upper and lower trim.
2) Slide the glass into the bottom glass support
and secure with the glass clips using the 2
phillips head screws at the top.
Note: To re-install the glass, reverse the
procedure.
Do not operate the appliance if the glass panel(s) are removed, cracked or broken.
Replacement of the glass panel(s) should be done by a qualified service person.

SAFETY SCREEN INSTALLATION / REMOVAL

1. To install the safety screen assembly onto the unit, lift assembly up and
lower tabs on safety screen onto pins inside unit as shown below.
Upper Trim
Lower Trim
The use of substitute glass will void all product warranties.
WARNING
2. Lower screen assembly onto unit, bottom of screen is secured by 2
magnets.
3. To remove–reverse steps.
Pin in unit
Tab on screen assembly
Magnet at bottom of screen
installation
Regency E21-10 Gas Fireplace Insert
®
|
21
| 21