Night Light™ Installation; Porcelain Base Installation - Napoleon HD81 Installation And Operation Instructions Manual

4
2.4 NIghT LIghT™ INSTALLATION
your hd81 comes equipped with 2 "night lights™".
the lights have been pre-wired and are controlled from the
remote control.
included with the burner assembly are the frames, lenses and
gaskets that need to be installed as shown in FIGURE 2.4a.
THE FIREBOx mUsT BE sEalEd.
over tightening the screws could break the lens.
"light leakage" from the holes in the housing lamp may be
observed. the holes in the lamp housing are necessary for
ventilation and must not be covered.
2.5

pOrCELAIN BASE INSTALLATION

the porcelain base is shipped separate from the unit and is
included with the burner assembly.
INsTall IN THE FOllOWING ORdER:
NOTE: Burner assembly must be installed first.
2.5.1 side porcelain panels or brick panels must be
installed prior to porcelain base and glass. For side
porcelain panel installation see "prp81
porcelAin reFlective rAdiAnt pAnel"
leaflet and for brick panel installation see "GD844KT
DECORATIVE BRICK PANEL - SANDSTONE" leaflet.
2.5.2. position the porcelain wire shields
in the bottom slots of the side porcelain panels.
there are tabs on the top of the shields so they can
only go in so far until they hit the firebox side.
carefully place the porcelain base
shields until it sits flat on the firebox base.
W415-0712 / 11.25.08
FIGURE 2.4a
FIGURE 2.4b
into the holes
1
porcelain Wire shields
2
over the wire
GASKET
LENS
FRAME
NIGHT LIGHT
2
1
1
FIGURE 2.5.1-2.5.2
porcelain
Base