Setting Up Hardware
1 Terminal Number Labels (Use Both Together)
2 Digital I/O Label
© National Instruments Corporation
Complete the following steps to set up the hardware:
1.
Install combicon screw terminal blocks by inserting them into the
combicon jacks.
2.
Figure 4 illustrates the signal labels that ship in the NI USB-6008/6009
kit. You can apply the signal labels to the screw terminal blocks for
easy signal identification.
1
ANALOG
2
3.
Refer to Table 3 and Figures 4 and 5 for signal label orientation and
affix the provided signal labels to the screw terminal blocks. Until the
signal labels are applied, you can insert the screw terminal blocks into
either of the combicon jacks.
DIGITAL
3 Single-Ended Label (Use Either)
4 Differential Label (Use Either)
Figure 4. NI USB-6008/6009 Signal Labels
7
NI USB-6008/6009 User Guide and Specifications
3
4