Log Placement - Napoleon GDS60-N Installation And Operation Instructions Manual

16

LOG PLACEMENT

Blocked burner ports can cause an incorrect flame pattern,
carbon deposits and delayed ignition. PHAZER
when exposed to direct flame and provide a unique and
realistic glowing effect. Use only certified PHAZER
available from your Napoleon dealer.
FIGURE 39a-d
4
2
Place log #1 onto the burner, centering it onto the burner
tray and pushing it as close to the rear wall of the firebox as
possible. Move logs # 2 and 3 into position, lining up the
studs located on the burner with the holes on the bottom of
the logs. Sit the notch at the bottom of log #4 against the
left outermost grate post and position the top of the log into
the pocket provided on the rear log (#1).
The notch in log #5 should be pressed down onto the
skewering pin located at the end of the grate as shown to
prevent it from rocking.
Position the notch located in log #6 against the grate post.
W415-0158 / E / 02.19.04
TM
logs glow
TM logs
1
3
5
6
Place the bottom of log #7 against the right outermost grate
post and the top into the pocket provided on the center log
(#6). Bend up the tab in the log support to cradle log #7.
Tear the glowing embers into pieces and place onto the
front of the burner. Care should be taken to shred the em-
bers into thin, small irregular pieces as only the exposed
edges of the fibre hairs will glow when exposed to direct
flame; however care should be taken to not block the burner
ports. Blocked ports can cause an incorrect flame pattern,
carbon deposits and delayed ignition.
Log colours may vary. During the initial use of the fireplace,
the colours will become more uniform as colour pigments
burn in during the heat activated curing process.
POSITIONING THE LOGS IMPROPERLY WILL CAUSE
FLAME IMPINGEMENT AND CARBONING.
7