Preparing The Arm-10 - Roland monoFab ARM-10 Printing Manual

5. Preparing the ARM-10

■ Attaching the liquid material vat
1. Loosen the liquid material vat retaining screws.
2. Insert the liquid material vat. Check that there is no dirt or foreign matter in the liquid material vat.
3. Securely tighten the liquid material vat retaining screws.
In the next step, the liquid material vat retaining screws are loosened by a fixed amount. For this reason,
the liquid material vat retaining screws are tightened securely at this stage.
Liquid material vat
Check that the liquid material vat stopper is
resting on the edge of the liquid material vat
15
Push in the liquid material
vat until its edge gently
touches the shutter lever