Operation; Remote Control; Flame Effect; Maintenance - Napoleon EF36H Installation And Operation Instructions Manual

REMOTE CONTROL

This fi replace is supplied with a radio frequency remote
control. This remote will function up to 20 feet away from
the fi replace.
The heater may emit a slight, harmless odour when fi rst
used. This odour is a normal condition caused by initial
heating of internal heater parts. Thereafter, any odour
is normally the result of household dust settling on the
heater element.
1. Turn the main power on at the control panel.
2. Using the hand held remote, turn the power on at the remote.
If the unit does not turn on, you will need to synchronize the
codes.
To synchronize the codes:
Press and hold the on button on the hand held remote.
Press the learn button on the control panel. See CONTROL
PANEL on page 9. Simultaneously hold both buttons in for
approximately 5 seconds.
To change the code on the transmitter:
a) Press the button under the battery compartment lid on the
transmitter.
b) Remove the battery from the transmitter and turn "off" the
main power on the control panel.
c) Wait 5 seconds and reinstall the battery and turn "on" the
power.
d) While pressing the "on" button on the hand held remote,
press the "learn" button on the control panel. See CONTROL
PANEL on page 9.
e) Hold both in for approximately 5 seconds
Note: The receiver will automatically advance to an
alternate code when introducing a transmitter to the
unit.
3. To turn the unit off, use either the remote or main power
button on the control panel or the manual on/off button on the
control panel.
4. The thermostat, located on the lower control panel, is
used to control the temperature of the room. To increase the
temperature, turn the dial clockwise.

OPERATION

The flame generator has a random modulating control
which causes the flame effect to speed up and slow
down sporadically. This action creates the realistic fl ame
appearance and can not be modifi ed.
Bulb Replacement : If you notice the fl ame look is darker
on one side of the fi replace, check the light bulbs to ensure
that one has not burned out.
Bulb must be replaced with a MAX 60 watt incandescent
clear light bulb.
1. To replace the bulb, turn the circuit breaker off or unplug
the appliance.
2. Open the lower louvres.
3. Detach the light access panel by removing the four
screws.
4. Replace the burned out light bulb using a new 60 watt
clear incandescent bulb.
5. Replace access panel.
6. Turn on the power or plug the appliance back in.
7. Turn on the main power and test.

FLAME EFFECT

MAINTENANCE

5
W415-0544 / 10.31.05