Log Placement; Charcoal Embers; Glowing Embers; Logo Placement - Napoleon BGD36PTR Installation And Operation Instructions Manual

24

LOG PLACEMENT

PHAZER TM logs and glowing embers exclusive to Napoleon Fire-
places, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully po-
sition the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the fireplace,
the colours will become more uniform as colour pigments
burn in during the heat activated curing process.
1. Place the back log (#1) onto the log support tray and in
front of the tabs. The tabs maintain an air space between
the log and firebox back to facilitate combustion air flow.
Ensure that the back of the log rests against the brackets
on the back wall of the firebox.
2. Move the two small logs (#2 & #3) into position, lining
up the studs located on the burner with the holes on the
bottom of the logs. Ensure that the small logs sit flat on the
burner.
3. Place the bottom of the left crossover log (#4) against
the left firebox side and pulled forward to the grate.
The top of the log should rest in the pocket on the back log.
W415-0210 / E / 06.25.03
FIGURE 46a-d
4. Position the notch located on the end of the center log
(#5) against the middle grate post with the other end of the
log resting in the pocket of the left crossover log.
5. Place the bottom of the right crossover log (#6) against
the right firebox side and pulled forward to the grate. The
top of the log should rest in the pocket provided on the
center log (#5).
Randomly place the charcoal embers along the front and
sides of the log support tray in a realistic manner. Fine
dust found in the bottom of the bag should not be used.
VERMICULITE (MODEL GD36 ONLY)
Sprinkle vermiculite around the charcoal embers.
Note: Note:
Note: Note: Note: Both charcoal embers and vermiculite are not to
be placed on the burner.
Tear the embers into pieces and place along the front row
of ports covering all of the burner area in front of the small
logs (#2 & #3). Care should be taken to shred the embers
into thin, small irregular pieces as only the exposed edges
of the fibre hairs will glow. The ember material will only
glow when exposed to direct flame; however, care
should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern,
carbon deposits and delayed ignition. PHAZER
when exposed to direct flame. Use only certified "glowing
embers" and PHAZER
leon dealer.
Remove the backing of the
logo supplied and place on the
glass viewing
indicated.

CHARCOAL EMBERS

GLOWING EMBERS

TM logs available from your Napo-

LOGO PLACEMENT

½"
door, as
FIGURE 47
TM
logs glow
LOGO
½"