Simpson MSV3024-I Instruction Manual page 9

WARNING: To reduce the risk of injury, read the pressure washer instruction manual and
the engine instruction manual before operating pressure washer.
Install the Handle
A
Place handle onto
frame, depress
the snap buttons, and
slide the handle assembly
onto the frame until snap
buttons snap into place.
DANGER:
• Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust
contains carbon monoxide, an odorless and deadly gas.
• Risk of fluid injection and laceration. When using the high pressure setting, DO NOT
allow the high pressure spray to come in contact with unprotected skin, eyes or with
any pets or animals. Serious injury will occur.
WARNING: Do not allow the unit to run for more than two minutes without the gun
trigger being pulled. This could cause overheating and damage to the pump. When
the temperature inside the pump rises too high, the thermal relief valve will open and
release a spray of water from the pump to lower the internal temperature. The valve
will then close.
Connect Garden
1
Hose to Pump
Thread the garden
hose to the pump inlet.
See Label #1 on the
back of the unit.
QUICK SETUP GUIDE
Add/Check Oil
B
The engine is
shipped without
oil. Before starting engine,
add the oil. Check oil level
prior to each use. Refer to
Engine Owner's Manual
for complete procedure.
QUICK START GUIDE
Connect High
2
Pressure Hose to
Pump
Thread the high pressure
hose to the pump outlet.
See Label #2 on the
back of the unit.
9 - ENG
Add Gasoline
C
In a well ventilated
outdoor area
add fresh, high quality,
unleaded gasoline with
a pump octane rating
of 86 or higher. Do not
over ll. Wipe up spilled
fuel before starting the
engine. Refer to Engine
Owner's Manual for
complete procedure.
Connect High
3
Pressure Hose to
Spray Gun
Thread the other end of
the high pressure hose
to the spray gun.