Simpson MSV3024-I Instruction Manual page 16

Table of Contents

Advertisement

Available languages

Available languages

• Never turn water supply off while pressure washer engine is running or damage to
pump will result.
• DO NOT stop spraying water for more than two minutes at a time. Pump operates
in bypass mode when spray gun trigger is not pressed. If pump is left in bypass
mode for more than two minutes internal components of the pump can be
damaged.
If you do not understand these precautions, please contact our customer service
department at www.simpsoncleaning.com
Prior to starting, refer to your engine manual for proper starting procedure.
1.
In a well ventilated outdoor area add fresh, high quality, unleaded gasoline
with a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled
fuel before starting the engine. Refer to Engine Owner's Manual for correct
procedure.
2.
Check engine oil level. See Engine Owner's Manual for correct procedure.
3.
Connect the water hose to the water source. Turn the water source on to
remove all air from the hose. When a steady stream of water is present, turn
the water source off.
4.
Verify the filter screen (M) is in water inlet of pump. NOTE: Convex side faces
out.
Connect water source (N) to pump inlet (J). NOTE: Water source must provide
5.
a minimum of 5 gallons per minute at 20 psi.
6.
Connect high pressure hose (C) to pump outlet (I).
8
M
WARNING: To reduce the possibility of contamination always protect
against backflow when connected to a potable water system.
7.
Choose the correct nozzle for the job to be performed. See how To Use spray
Wand instructions in this section. NOTE: If applying a chemical or cleaning
solution, see how To Apply Chemicals/Cleaning Solvents instructions in this
section.
8.
Turn water source on.
NOTICE: Risk of property damage. Failure to do so could cause damage to the
pump.
9.
Remove all air from the pump and high pressure hose by depressing trigger
until a steady stream of water is present.
10. Start engine. See Engine Owner's Manual for correct procedure.
WARNING: Risk of unsafe operation. If engine does not start after two
pulls, squeeze trigger of gun to relieve pump pressure. Pull starter cord slowly
until resistance is felt. Then pull cord rapidly to avoid kickback and prevent
hand or arm injury.
NOTICE: Use of fuels with greater than 10% ethanol are
not approved for use in this product per EPA regulations
and will damage the unit and void the warranty.
9
16- ENG
10
J
I
N
C

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents