Advertisement
4/98
$GGUHVV 3KRQH 1XPEHU
&RQWURO
• Dial Pulse: If programmed, the panel will dial to
phone number 1, 2, or 3 using a pulse format.
• Dial Tone: If programmed, the panel will dial to
phone number 1, 2, or 3 using a tone format.
Note: When dialing through PBX systems,
program the phone control as tone dial only.
• Tone with Auto Switch to Pulse: If programmed,
the control panel will try to dial the first digit in tone
dial and check to see if the dial tone has been
broken. If it has not been broken, it will try to dial
again using pulse dial.
Note: Do not use this setting for PBX systems.
• Tone with No Switch to Pulse (required for
PBX): This setting will only use Tone dialing. Must
be used if the telephone system requires you to
dial a number to get an outside line.
• Callback for Downloading: When enabled, if an
attempt is made to connect to the panel for a
remote programming session the panel will hang
up and callback the number programmed for
Phone 3, Address 44 and 45.
• Ring Count: The control panel can be
programmed to answer the phone after a selected
number of rings for remote programming access.
• WDSRP Baud Rate: This selection determines the
baud rate that the panel will use to
Page 14
• Answering Machine Bypass: This feature allows
• Dialer Delay: A Dialer Delay of 15 seconds can
$GGUHVV 'LDO $WWHPSWV
$GGUHVV 7LPH 'HOD\V
Copyright © 1997-98 Detection Systems, Inc.
the control panel to answer incoming calls when
answering machines are used. If the line rings,
stops ringing, then rings again within one minute,
the panel will seize the phone line on the first ring.
To disable this feature, program the control panel
to answer on an even number of rings.
be added when reporting burglar alarms, 24-hour
burglar alarms, and fire alarms. This delay will help
to prevent false alarm reports by giving the user 15
seconds to disarm the system before a report is
sent.
DS7060-AUS Reference Guide
Advertisement
