Removing The Thermal Cooling Assembly; Replacing The Thermal Cooling Assembly - Dell inspiron M4040/14-N4050 Owner's Manual

Table of Contents

Advertisement

Back to Contents Page
  Thermal Cooling Assembly
Dell Inspiron M4040/14-N4050 Owner's Manual
  Removing the Thermal Cooling Assembly
  Replacing the Thermal Cooling Assembly
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
 
CAUTION:
To help prevent damage to the system board, remove the main battery, see
NOTE:
Based on the selection you made at the time of purchase of your computer, location of the fan cable and dimensions of the thermal cooling
assembly may vary.
 Removing the Thermal Cooling Assembly
 
1. Follow the instructions in
Before You
 
2. Remove the battery. See
Removing the
 
3. Follow the instructions from
 
4. Disconnect the fan cable from the connector on the system board.
 
5. In sequential order (indicated on the thermal cooling assembly), loosen the four captive screws that secure the thermal cooling assembly to the system
board.
 
6. Lift the thermal cooling assembly away from the computer.
1
thermal cooling assembly
3
captive screws (4)
 Replacing the Thermal Cooling Assembly
 
1. Follow the instructions in
Before You
 
2. Align the four captive screws on the thermal cooling assembly with the screw holes on the system board and tighten the screws in sequential order
(indicated on the thermal cooling assembly).
 
3. Connect the fan cable to the connector on the system board.
 
4. Follow the instructions from
 
5. Replace the battery. See
Replacing the
Begin.
Battery.
step 3
to
step 8
in
Removing the Palm-Rest
2
fan cable
Begin.
step 3
to
step 7
in
Replacing the Palm-Rest
Battery.
Removing the
Battery, before working inside the computer.
Assembly.
Assembly.

Advertisement

Table of Contents
loading

Table of Contents