Removing The Camera Module; Replacing The Camera Module - Dell inspiron M4040/14-N4050 Owner's Manual

Back to Contents Page
Camera Module
Dell Inspiron M4040/14-N4050 Owner's Manual
Removing the Camera Module
Replacing the Camera Module
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery, see
Removing the Camera Module
1. Follow the instructions in Before You
2. Remove the battery. See Removing the
3. Follow the instructions from
4. Remove the optical drive. See
5. Remove the USB board. See "Removing the USB Board" on page 47.
6. Remove the hinge cover. See
7. Remove the display assembly. See
8. Remove the display bezel. See
9. Disconnect the camera cable from the connector on the camera module.
10. Release the tabs that secure the camera module to the display cover and lift the camera module off the display cover.
1 camera module
3 tabs (2)
Replacing the Camera Module
Begin.
Battery.
step 3 to step 8 in Removing the Palm-Rest
Removing the Optical Drive.
Removing the Hinge Cover.
Removing the Display Assembly.
Removing the Display Bezel.
2 camera cable
Removing the Battery, before working inside the computer.
Assembly.