Camera Feature Locations; Front View - Panasonic KX-HCM280 Operating Instructions Manual

Operating Instructions

1.3 Camera Feature Locations

1.3.1 Front View

Indicator
Indicator can be controlled on Indicator Control window on page 92. Colour
indications are shown below.
Power
on
Normal Operation
Using
DHCP
Finish getting IP address
Updating Firmware
Pushing FACTORY DEFAULT RESET button
Internal Failure of Network Camera
* Orange indicator will continue blinking in the DHCP setting.
1
* Refer to page 123 for the red blinking.
2
Lens and Pan/Tilt operation
Operation bar on the Single Camera screen can control the Pan/Tilt. The Pan/Tilt
moves the lens horizontally from -175° to +175° and vertically from -120° to 0° in
mounting on the table and from 0° to +90° in mounting on the ceiling. Refer to
page 44 for Pan/Tilt operation.
Notes
• Accidentally revolving or turning the Pan/Tilt mechanism while the camera is
powered up may cause the memorised camera positions to change. If this
occurs, restart the camera by momentarily disconnecting power.
• Do not touch the lens. Touching it can remove the protective coating from the
lens. Fingerprints, dust, stains, etc. on the lens can also degrade the
performance of the Automatic Focusing feature.
14
Lens (Power Focus/Zoom Lens)
Wide: 5 mm—Infinity
Tele: 1 m—Infinity
(Refer to page 45.)
Indicator
(Refer to page 92 for the setup.)
Not on the LAN
On the LAN
Getting IP address
Orange Orange blinking*
Orange Orange/Green blinking
Green blinking
Orange blinking
Orange blinking twice
Red blinking*
1
Orange
Green
Green
2
Green