Installing The Drain Hose - Akai XQB100-Y1066S Instruction Manual

Getting Started: Installation (Cont.)

Installing the drain hose

• Pinching the two bands of the clamp on the drain hose, connect it to the drain
pump at the back of the washer (see the photo below, left).
• Pull the drain hose upward and affix it to the hose clip at the back of the washer, as
illustrated below, right.
• When the washer is in use, put the drain hose into a drain spout (or into a sink/tub),
as illustrated on page 10.
Drain pump with lint filter
CAUTION!
• While the washer is in use, make sure the height
of the drain hose is at least 80cm, otherwise the
washer will not work well, or the water may flow
out in the course of washing. Also ensure the
drain hose is not higher than 120cm
above ground, otherwise the washer
will not drain water well.
• Never lay down the drain hose, as
water will be discharged.
• Be sure the drain hose is properly
routed so it will not kink or lift off
the sink.
10
.