Step 11 Installing Trim, Logs And Ember Material; Installing The Trim; Positioning The Logs; Shutter Settings - Heat-N-Glo 6000TRXI Installer's Manual

Step 11. Installing Trim, Logs,
and Ember Material

Installing the Trim

Combustible materials may be brought up to the specified
clearances on the side and top front edges of the fireplace,
but MUST NEVER overlap onto the front face. The joints
between the finished wall and the fireplace top and sides
can only be sealed with a 300° F. (149° C) minimum sealant.
WARNING: WHEN FINISHING THE FIREPLACE,
!
NEVER OBSTRUCT OR MODIFY THE AIR IN-
LET/OUTLET GRILLES IN ANY MANNER.
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the fireplace.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that the
bottom grille can be lowered and the trim door removed.

Positioning the Logs

If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the instructions that accompany the
logs. Save the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.

Shutter Settings

___________________________________________
Left Log
___________________________________________
Right Log
___________________________________________
Burner

Placing the Ember Material

Ember material is shipped with this gas fireplace. To place
the ember material:
• Pull the four glass latches out of the groove on the glass
frame. Remove glass door from the unit (see Figure 43).
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• When placing embers onto the burner care should be
taken so that the ports are not covered. Place the em-
bers along side the port trail, but not on or in between
the ports. Failure to follow this procedure will likely cause
lighting and sooting problems.
• Save the remaining ember materials for use during fire-
place servicing.
• Replace the glass door and a front trim door on the unit.
• Pull out and latch the glass clips into the groove on the
glass frame.
NG LP
3/8" SET
3/8" SET
3/8" FULL
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 43. Glass Assembly

Glass Specifications:

6000TRXI: 24 1/2 X 35 1/2
RETAINING
SCREW
(BOTH SIDES)
BURNER
Figure 44.
Burner Removal
30
CERAMIC