Table of Contents
Advertisement
Step 10. Installing Trim, Logs and Ember
Material, and Removing Shipping Support
Installing the Trim
Combustible materials may be brought up to the specified
clearances on the side and top front edges of the fireplace,
but MUST NEVER overlap onto the front face. The joints
between the finished wall and the fireplace top and sides
can only be sealed with a 300° F. (149° C) minimum sealant.
WARNING: WHEN FINISHING THE FIREPLACE,
!
NEVER OBSTRUCT OR MODIFY THE AIR INLET/
OUTLET GRILLES IN ANY MANNER.
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the fireplace.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that the
bottom grille can be opened and the trim door removed.
Removing Grate Shipping Support
•
Remove the log pack and hood, if applicable.
•
Bend top retaining tab of grate shipping support into
vertical position (see Figure 39).
•
Lift grate slightly upward with one hand so that the grate
clears the support.
•
Slide shipping support to side, remove and discard.
•
Lower grate onto refractory.
Figure 39.
Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the instructions that accompany the
logs. Save the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
Placing the Ember Material
Ember material is shipped with this gas fireplace. The bag
labeled Mystic Embers is standard glowing ember material.
To place the ember material:
• Remove the top louver by lifting it up and away from the unit.
• Unlatch the latches at the top and bottom of the glass door.
• Remove the glass door from the unit (see Figure 40).
• Embers CAN be placed directly over ports, but ONLY
on burner front. Care should be taken not to cover the
lighting trail of ports (from back to front).
• When placing embers onto BACK of burner do not place
directly on top of ports. Embers can be set just in front
of rear ports and then pushed back to just slightly over-
lap, BUT NOT COVER the ports. This will increase the
glowing effect and give the look of hot coals and ashes.
• Save the remaining ember materials for use during fire-
place servicing. The bag of embers provided is sufficient
for 3 to 5 applications.
• Reinstall and latch the glass door and top louver on the unit.
CAUTION: THE GLASS DOOR MUST BE SECURELY
LATCHED BEFORE OPERATING THE UNIT.
LATCHES
(BOTH TOP
AND BOTTOM)
GLASS
ASSEMBLY
Figure 40. Glass Assembly
GLASS SPECIFICATIONS:
SL-750TRS-C
SL-550TRS-C
SL-350TRS-C
39
24 5/8 x 35 3/8
CERAMIC
21 1/8 x 30 3/8
CERAMIC
19 x 21 1/2
CERAMIC
Hide quick links:
Advertisement
Table of Contents
