Step 11 Installing Trim, Logs, And Ember Material; Installing The Trim; Positioning The Logs; Shutter Settings - Heat-N-Glo 6000 TRI Installer's Manual

Step 11. Installing Trim, Logs,
and Ember Material

Installing the Trim

Combustible materials may be brought up to the specified
clearances on the side and top front edges of the fireplace,
but MUST NEVER overlap onto the front face. The joints
between the finished wall and the fireplace top and sides
can only be sealed with a 300° F. (149° C) minimum sealant.
WARNING: WHEN FINISHING THE FIREPLACE,
!
NEVER OBSTRUCT OR MODIFY THE AIR INLET/
OUTLET GRILLES IN ANY MANNER.
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the fireplace.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that the
bottom grille can be lowered and the trim door removed.
RETAINING
SCREW
(BOTH SIDES)
BURNER
Figure 43.
Burner Removal

Shutter Settings

___________________________________________
Log
___________________________________________
Burner

Positioning the Logs

If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the instructions that accompany the
logs. Save the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
NG LP
1/4" 1/4"
3/16" 3/8"

Placing the Ember Material

Ember material is shipped with this gas fireplace. To place
the ember material:
• Pull the four glass latches out of the groove on the glass
frame. Remove glass door from the unit (see Figure 44).
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 44. Glass Assembly
• Embers CANNOT be placed directly over ports.
Care should be taken not to cover the lighting trail
of ports (from back to front).
• When placing Glowing embers onto the burner care
should be taken so that the ports are not covered.
Place the embers along side the port trail, but not
on or in between the ports (see Figure 45). Failure
to follow this procedure will likely cause lighting and
sooting problems.
Figure 45. Placement of the Ember Material
31
EMBER MATERIAL