Macropower™ Total System; On/Off; Channels; Control - Universal Remote Control WR7 Owner's Manual

MacroPower™ Total System On or Off
MacroPower makes several devices work
together while pressing just one button. If you
want to turn on your TV, DVD player and
Surround Sound receiver by pressing a single
button, you can. Both the Power Onand the
System Off buttons can be set up for MacroPower

control.

Note: Most components use the same signal
to turn the power on and off. You may want to
set-up MacroPower only in the POWER [ON]
button and save the [SYSTEM OFF] button to
turn components on or off individually.
STEP 1: To set-up MacroPower for the POWER
[ON] button, press the POWER [ON] button
and the [MUTE] button at the same time for two
seconds until any one of the Component lights
turns on. Release the buttons before going on to
step 2.
POWER SYSTEM
ON OFF
CHANNEL
5
MUTE
UP
STEP 2: Press the component button you want to
turn on and then press the POWER [ON] button;
repeat for all other components in the order you
want them to turn on. The Component light will
blink once each time you press the POWER [ON]
button.
Note: If you do not press a button within 30
seconds, the component light will turn off. The
remote will exit the set-up mode, and you will
have to start over with step one.
STEP 3: Once you've entered all the Power On
5
commands, press the CHANNEL Up [CH ]
button to save your MacroPower commands. The
Component light will blink three times to confirm
that the activation has been successfully saved.
Repeat for System Off button if desired.
Page | 20