Table of Contents
Advertisement
The glass panel assembly should be installed after the fireplace is
completely framed and finished. The brackets are attached to the
front side face of the fireplace using two screws as shown in Figure
25. Position the glass panel in the bracket so that it is securely in
place. The glass panel can be placed in two different height locations.
Bracket
Screws
Glass
Panel
Figure 25 - Installing Glass Panel
GAS CONTROL MODULE SYSTEM
REMOTE CONTROL FEATURE
The module has a built in remote control receiver that allows the
user to program the remote transmitter at any time during or after
the installation of the burner.
1.
There is a switch located on the right side of the module that
reads REMOTE/OFF (Figure 26).
2.
When the remote/off switch is in the OFF position, the burner
will operate from the rocker switch or wall switch connected to
the two BROWN wires on the module.
3.
When the remote/off is in the REMOTE position the burner will
operate from the Remote Control Transmitter.
NOTE: The module must be programmed to the Remote Control
Transmitter.
•
To program the module (make sure the system has power),
locate the learn button (Figure 27) on the module. Locate the
metal shield that is covering the module and remove the screw
on top. Use a small thin object like a paper clip (not sharp points)
to press and release the learn button. There will be a beep sound
from the module. Then press any button on the remote transmit-
ter. Once the module's internal receiver accepts the transmitter
code, there will be a series of confirming beeps.
•
The remote system is ready for use.
127035-01C
INSTALLATION Continued
•
Pushing and holding the LEARN button for 6 seconds will result
in clearing the transmitter security code from the module's
memory. The module will make three long beeps in succession
when it has been cleared.
IGNITOR ASSEMBLY
The ignitor assembly is factory preset for proper ignition of the burner.
Alterations may have occurred during shipping and handling. Call a
qualified service person to readjust the ignitor assembly if necessary.
The ignitor should be positioned as shown in Figure 28.
Note: Figure 28, shows the correct positioning of the ignitor and
sensing rod.
If your ignitor assembly does not meet these requirements:
• turn appliance off (see To Turn Off Gas to Appliance, page 14).
• see Troubleshooting, page 17.
Note: Reference only, not to scale
SuperiorFireplaces.US.com
ADJ.
Remote/Off Switch
"S" Pilot Connection
"I" Pilot Connection
AF-4000 MOD Module Rt Side
Figure 26 - Gas Module Right Side
Learn Button
AUX Connection
AF-4000 MOD Module Lt Side
Figure 27 - Gas Module Left Side
Ignitor
Ground
Electrode
Sensing
Rod
0.8000
Figure 28 - Ignitor
Spark
Gap
0.120
13
Hide quick links:
Advertisement
Table of Contents
