Superior VRE4543EN Installation And Operation Instructions Manual page 12

Installing Access Door
1. Place access door into rectangular opening in front of the glass
door with the slanted side facing forward. The slanted surface will
slide underneath the flange of the bottom face Insert tabs on side
of access door into slots on retaining brackets (See Figure 22).
Side
Filler
Flange on
Face Bottom
Figure 22 - Access Door for See-Thru Applications
Installing Hood
1. Install hood as shown in Figure 15 page 10.
Locating Control Module
1. Remove Access Plate (See Figure 22).
2. Remove 2 screws on top of the electronic access cover (See Figure
23).
3. Remove electronic access cover by gently pulling up and out of
the fireplace. There are two switches connected to cover.
4. The control module is located on the left as shown in Figure 24.
Electronic
Access Cover
Figure 23 - Removing Control Access Cover (Face Bottom not
shown for Clarity)
12
INSTALLATION Continued
Access
Door
Remove
Screws
SuperiorFireplaces.US.com
5. Light switch is located on the right hand side as shown in Figure
24.
6. ON/OFF switch is located on the left hand side as shown in Figure
24.
ON/OFF
Remote
Switch
Receiver
Gas
Module
Figure 24 - Control Module (Face Bottom not shown for Clarity)
GLASS PEBBLE INSTALLATION
WARNING: Do not change or substitute glass
pebbles provided with this fireplace. If replacing, use
only replacement glass pebbles. See Replacement
Parts page 23.
Green glass pebbles are included with your fireplace.
1. Place glass pebbles in a single layer evenly on the pebble pan.
Make sure not to place any on the burner in the center of the
pebble pan.
GLASS PANEL INSTALLATION
WARNING: Do not slam or strike glass panel.
Damage can result in a hazardous condition.
Discontinue use of the appliance immediately if glass panel is
damaged and contact a qualified installer for repair. Only glass
panel certified with the appliance shall be used.
Backup
Light
Battery
Switch
127035-01C