Log Placement - Napoleon BGD40-N Installation And Operating Instructions Manual

9.5

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
Phazer TM logs, glowing and charcoal embers, exclusive to Wolf Steel Ltd. appliances, provide a unique and
realistic glowing effect that is different in every installation. Take the time to carefully position the embers for a
maximum glowing effect.
LOCATING SCREWS
f i r e - p a r t s . c o m
Looking at the unit from the valve side, place
A.
the fi bre burner onto the locating screws on
the pan burner as illustrated above. It is im-
portant not to cover any burner ports with the
fi bre burner.
Depending on the type of installation, the
C.
view of the log positioning will reverse. Here
the lower end of log #2 rests near the back
left corner of the fi rebox on the locating pin.
The upper end sits on top of log #1, inside
the groove on log #2.
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
LOCATING
STUDS
WARNING
!
Place log #1 diagonally across the textured
B.
burner onto the pins. The texture is
designed to cradle the underside of the log.
Log # 3 is made up of two pieces, a and b.
D.
Piece #3a is the base of log #3. The base
sits diagonally in the designated area located
between logs #1 and fi ts tight up against #2.
37
76.1A
W415-0811 / D / 08.16.12