Drainage Instruction - Dimplex DXDH10N Installation And Operating Instructions Manual

6. Other than on the case of note 2 above , where the dehumidifier does not
start, the operational light does not illuminate or the dehumidifier
intermittently stops for unknown reasons, please check the plug and power
supply for poor connection. If the plug and power supply are in good
condition, wait for 10 minutes and restart the unit (it can take about 10
minutes for the unit to reset). If the unit still does not start after 10 minutes,
please contact your retailer or the manufacturer for repair.
7. When the dehumidifier is in operation, the running compressor will
produce heat , this is normal , this may potentially raise the room
temperature.

DRAINAGE INSTRUCTION

The extracted water can be collected by water tank(set up as supplied), or can
be set up to drain continuously using a
PVC hose (see details below, not included):
USE OF WATER TANK:
When the water full indicator illuminates, the tank is
full, and the compressor and the fan will stop
operation, please empty the water tank:
Remove the water tank as per Fig 01. and empty it.
Gently refit the water tank into the unit in its original position.
CONTINUOUS DRAINAGE
1. If you want to use this function, please pull out
the water tank and plug a 9mm internal diameter
water pipe onto the "Water out tube" (See
Fig.02). replace the water tank into the unit, the
unit will now operate while discharging the
extracted water through the free end of the fitted
pipe, (note, please ensure the free end is below the outlet connection).
Fig 01
Fig 02