Yamaha SRX700D Service Manual page 232

1 Starter cable
2 Fasten the starter cable, oil
pump cable, and coolant hose
with a plastic band without
bending them.
3 Ignition coil coupler
4 T.O.R.S. connector
5 Water temperature sensor
coupler
6 Fasten the wire harness, water
temperature sensor lead,
coolant hose, T.O.R.S.
connector, ignition coil lead
and throttle position sensor
lead with a plastic band.
7 Fasten the wire harness and
coolant hose at the spots
marked with white paint.
8 Fasten the wire harness and
coolant hose at the spots
marked with white paint.
9 To the carburetor
0 The AC magneto coupler and
rubber cover should be
positioned below the coolant
hose.
A Throttle position sensor
coupler
B Fasten the wire harness,
coolant hose and throttle
position sensor lead at the
spots marked with white paint.
C Wire harness
CABLE ROUTING
9-32
SPEC