Yamaha SRX700D Service Manual page 230

N To the carburetor
O Vacuum hose
P Oil hose
Q Reservoir tank hose
R Oil hose
S Wire harness
T To the oil pump
U Fasten the wire harness at the
white tape mark, with a clamp.
V Route the wire harness and
coolant hose next to each
other.
W Pass the brake hose through
the hose guide.
X Do not loosen the tail/brake
light lead clamp.
Y Fasten the tail/brake light lead
with a plastic band (at the
white tape mark).
Position the plastic band next
to the starter rope guide, as
shown.
Z Route the coolant reservoir
tank hose behind the brake
hose.
[ Does not kink.
\ To the coolant reservoir tank.
] Fasten the wire harness, fuel
tank breather hose and oil tank
breather hose with a plastic
band.
` Install the starter lever to the
position as illustrated.
CABLE ROUTING
9-30
SPEC