Table of Contents
Advertisement
To mount the unit on a pole....
1
b
To flush mount the unit....
3
4
Securely attach the pole mount base to a
1
suitable pole.
Pass the cable and connector through either
2
the center of the pole mount bracket and
a
the pole, or
3
the cable exit hole alongside the center
b
hole.
Attach the connector securely to the plug in
3
the base of the unit.
2
Secure the receiver to the pole mount base
4
using the screws provided.
Notes:
1. To mount the receiver on a pole, you will
need a pole of suitable length with a 1 inch
a
14 TPI thread not exceeding 20mm in
length.
2. To rail mount the receiver you will need to
purchase a suitable rail mount bracket.
4
1
Use the template supplied in this handbook to
mark the two fixing holes and the center hole.
Drill the holes using the drill sizes shown on
2
the template.
Screw the two fixing studs into the underside
3
5
of the receiver unit.
Place the waterproof gasket into position on
4
the underside of the receiver.
Attach the connector securely to the plug in
5
the base of the unit and pass the cable
through the center hole on the mounting
surface.
Carefully position the receiver so that the
6
mounting studs pass through the holes in the
mounting surface.
Secure the receiver to the mounting surface
7
using the two thumb nuts (these should be
7
hand-tight only).
3
Advertisement
Table of Contents
