Ix. Care And Maintenance - Pride Icon Owner's Manual

I X . C A R E A N D M A I N T E N A N C E
WIRING HARNESSES
! Regularly check all wiring connections.
! Regularly check all wiring insulation, including the charger power lead, for wear or damage.
! Have your authorised Pride Dealer repair or replace any damaged connector, connection or insulation
that you find before using your scooter again.
ABS PLASTIC SHROUDS
! The front tiller shroud, front shroud and the rear shroud are formed from durable ABS plastic and are
coated with an advanced formula urethane paint.
! A light application of car wax will help the shrouds retain their high gloss.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodi-
cally for wear by your authorised Pride Dealer.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
You do not need to lubricate these items, as they are all prelubricated and sealed
CONSOLE, CHARGER AND ELECTRONIC CONTROLLER MODULE
! Keep these areas away from moisture.
! Before operating your scooter, allow any of these areas to dry thoroughly if they have been exposed to
moisture.
HANDBRAKE (OPTIONAL)
The handbrake lever may require periodic adjustment to maintain proper operation. Contact your authorised
Pride Dealer for more information.
FUSES
To replace a fuse:
1. Remove the fuse by pulling it straight out of its slot.
2. Examine the fuse to be sure it is blown. See figures 19 and 20.
3. Insert a new fuse of the proper rating.
WARNING! The replacement fuse must exactly match the rating of the new fuse. Failure
to use properly rated fuses may cause damage to the electrical system and may result in
personal injury.
36
Figure 19 Working Fuse
www.pridemobility.com
Figure 20. Blown Fuse (Replace)
Icon