Care And Maintenance - Pride Pursuit 2 Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

V I I . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confi dent in your ability to
perform the maintenance listed below, you may schedule inspection and maintenance at your authorized Provider.
The following areas require periodic inspection and/or care and maintenance.
TIRE PRESSURE
 If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure rating indicated on each tire.
WARNING! It is important that the psi/bar/kPa air pressure rating indicated on each tire be
maintained in pneumatic tires at all times. Do not underinfl ate or overinfl ate your tires. Low
pressure may result in loss of control, and overinfl ated tires may burst. Failure to maintain the
psi/bar/kPa air pressure rating indicated on the tires at all times may result in tire and/or wheel
failure.
 Regularly inspect your scooter's tires for signs of damage or wear.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefi t from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter's vinyl seat or tire tread, as
this may cause them to become dangerously slippery.
CLEANING AND DISINFECTION
Precautions must be taken when cleaning equipment/devices to lower the risk of spreading infection. This is to
limit the spread of illness and other potentially infection material (OPIM) (blood components).
 Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter. Avoid
using products that may scratch the surface of your scooter.
 If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on
your product before application.
HOW TO CLEAN/DISINFECT EQUIPMENT:
HARD/SOFT SURFACES
tires, armrests and footplate mats, as applicable)
 For hard/soft surfaces, remove visible contamination if present.
● For plastic and metal use Lysol®/Clorox® disinfecting spray/wipes
and other qualifi ed SARS-CoV-2 disinfecting products.
● For other vinyl surfaces, clean with vinyl safe disinfecting wipes or
solutions.
Suggested Disinfectants
Birex® SE Disinfectant, Bleach-Rite® Disinfecting
Spray, Citrace® Germicide
Dispatch® Spray Hospital Cleaner Disinfectant with
Bleach
Diluted Bleach Solution (10% dilution or less);
Note: Bleach with pH factor between 7 and 9 is
suitable; a product with a pH of 10.5 or higher may
damage the vinyl surface integrity over an extended
period of time.
Disinfecting Wipes
Clorox, Green Works, PDI Sani-Cloth HB Wipes
Lysol, Oxivir, Virox, and CaviWipes.
● For Tire cleaning, clean with off the shelf tire/wheel cleaners
SC7132
(Plastic shrouds, metal framing, seat fabric,
29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc7132

Table of Contents