Multi-Stitch Movement - Pfaff 918 U Instruction Manual

12

Multi-stitch movement

.05.08
Requirement
1. When the needle, at its b.d.c., penetrates on the right-hand side, the recess 5 on the
control cam 3 should be positioned horizontally towards the rear.
2. The lateral movement of the needle bar should have been completed when the needle
penetrates the workpiece (carry out a check with the largest zigzag setting).
5
Fig. 12 - 09
Set the adjustment wheel 1 at multi-stitch.
Set the zigzag stitch width lever 2 at "largest zigzag width".
Adjust control cam 3 (screws 4) in accordance with the requirement.
2
Adjustment
3
4
92-029
1
12 - 10