Power Seat Lift - Quickie Xplore 2 Hybrid Owner's Manual

I. Power Seat Lift (Standard Operating Instructions)
WARNING!!!
Make sure the wheelchair is on a level surface before
proceeding with Lift mode and driving in reduced speed
while lifted.
SINGLE ACTUATOR TOGGLE SWITCH
Increasing Lift Height
Pull the toggle switch (located next to the wheelchair
joystick) backward toward the rear of the wheelchair until
the desired Lift Height is achieved, then release.
SINGLE ACTUATOR TOGGLE SWITCH
Decreasing Lift Height
To decrease the Lift Height. Release the toggle switch to
the neutral position for a minimum of 1 second and push
the toggle switch (located next to the wheelchair joystick)
forward toward the front of the wheelchair until the desired
Lift Height is achieved, then release.
Driving in Reduced Speed
Is a feature designed to allow the user to drive the
wheelchair at a reduced speed while lifted up to 11".
When lifted, the drive speed is then reduced to 30% of its
original setting. Full drive speed is achieved when the
seat lift is down to its lowest position.
DANGER!!!
Never operate the seat lift when the wheelchair is in any
slope. In reduced speed, the wheelchair must be driven
on a level surface relative to the vertical position. If the
reduced speed does not slow the wheelchair's drive
speed to 30% of its original settings, have the wheelchair
or power seat lift system serviced by an authorized dealer
or qualified technician.
Quickie Xplore 2 Owner's Manual Rev. A 21