O.cg Tilt Power Accessory; Lift Power Accessory; Q.power Recline; Power Legrest Accessory - Quickie Xplore 2 Hybrid Owner's Manual

O.CG TILT POWER ACCESSORY

The powered CG Tilt accessory for this chair has a maximum user
weight capacity of up to 400 lbs. Never exceed this capacity while
operating the powered actuator.
P. LIFT POWER ACCESSORY
The powered lift modular accessory for this chair has a maximum
user weight capacity of up to 300 lbs. Never exceed this capacity
while operating the powered actuator.

Q.POWER RECLINE

Pinch Point
Avoid putting hands or fingers near the power recline mechanism
while in operation.
Weight Capacity
The maximum user weight capacity for the power recline is up to
400 lbs. Exceeding this weight capacity could lead to injury and/or
permanent damage to the equipment.
R. POWER LEGREST ACCESSORY
The power legrest accessory for the Xperience has a maximum
user weight capacity of up to 300 lbs or 400 lbs depending
on your chair configuration. Never exceed this capacity while
operating the powered actuator.
S. TRANSIT USE
Your chair has been manufactured with built-in Transport Brackets
on.
These transport brackets have not been crash-tested in
accordance with WC-19. Use these transport brackets only to
secure an unoccupied wheelchair during transport
1. NEVER let anyone sit in this chair while in a moving vehicle.
2. NEVER transport this chair in the front seat of a vehicle. It may
shift and interfere with the driver
3. ALWAYS secure this chair so that it cannot roll or shift.
4. Do not use any chair that has been involved in a motor vehicle
accident.
Quickie Xplore 2 Owner's Manual
WARNING
WARNING
WARNING
WARNING
SET UP, ADJUSTMENT AND USE

NOTES

1. Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and
check your chair. This makes the steps easier and helps ensure
a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are special
highstrength fasteners and may have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert to
help prevent loosening.
• Only use screws, bolts and nuts provided by Sunrise.
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or cause damage to
chair parts.
3. If bolts or screws become loose, tighten them as soon as you
can. Loose bolts or screws can cause damage to other chair
parts causing them to fail.
3. Washers & Spacers:
• Note the position of washers and spacers before disassembly.
• To avoid damage to the frame, replace all washers and
spacers when you reassemble parts.

TOOLS YOU WILL NEED

1. Basic Tool Kit:
To set-up, adjust and maintain your chair you may need the
following tools:
• Combined Phillips and flat screw driver
• Standard metric wrenches from 10mm
• Metric Allen wrenches from 5mm
• Imperial wrenches from 1/4" to 9/16"
• Imperial Allen wrenches from 5/64" to 1/4"
You can obtain a multi-purpose tool kit from Sunrise, or buy the
tools you need from a hardware store.
2. Torque Wrench:
If you plan to adjust and maintain this chair yourself, Quickie
recommends that you use a torque wrench.
Q-NOTE- The wrench must measure inch-pounds (N.m). You
can buy a torque wrench and proper sockets from a hardware
store.
Rev. A
WARNING
13