Page 1
LL COURT Quickie All Court / All Court Ti ® Supplier: This manual must be given to the user of O w n e r ’ s M a n u a l this wheelchair. User: Before using this wheelchair read this entire manual and save for future reference.
Quickie supplier. Please feel free to write or call us at the address and telephone number below: Sunrise Medical Customer Service Department 2842 Business Park Ave Fresno, CA 93727 800.333.4000...
A L L C O U R T II. T BLE OF CONTENTS I. INTRODUCTION ........... VIII. WARNINGS: COMPONENTS & OPTIONS..II. TABLE OF CONTENTS.......... A. Anti-Tip Tubes ............III. YOUR CHAIR AND ITS PARTS ......B. Armrests ..............IV. NOTICE - READ BEFORE USE......C.Cushion &...
A L L C O U R T IV. NOTICE– RE D BEFORE USE A. CHOOSE THE RIGHT CHAIR & SAFETY C. WARNINGS OPTIONS The word “WARNING” refers to a hazard or unsafe practice that may cause severe injury or death to you or to other persons. Quickie provides a choice of many wheelchair styles to meet the The “Warnings”...
A L L C O U R T V. GENER L W RNINGS F. CHANGES & ADJUSTMENTS J. MOTOR VEHICLE SAFETY WARNING WARNING 1. If you modify or adjust this chair, it may increase the risk of a Quickie wheelchairs do not meet federal standards for tip-over UNLESS you make other changes as well.
A L L C O U R T VI. W RNINGS: F LLS & TIP-OVERS 2. Do not attempt a “wheelie” UNLESS you are a skilled rider VI. WARNINGS: FALLS & TIP-OVERS of this chair or you have help. NOTE– See Section VII-A for steps to learn to do a “wheelie.” A.
A L L C O U R T VI. W RNINGS: F LLS & TIP-OVERS e. Rotate the front casters until they are as far forward as have guardrails (or raised borders at least three inches high). possible. This makes the chair more stable. c.
A L L C O U R T VI. W RNINGS: F LLS & TIP-OVERS J. STAIRS K. ESCALATORS WARNING WARNING 1. NEVER use this chair on stairs UNLESS you have someone NEVER use this chair on an escalator, even with an to help you.
A L L C O U R T VII. W RNINGS FOR S FE USE F. MAINTENANCE WARNING 1. Inspect and maintain this chair strictly per chart. 2. If you detect a problem, make sure to service or repair the chair before use.
A L L C O U R T VIII. W RNINGS: COMPONENTS & OPTIONS F. PNEUMATIC TIRES I. PUSH HANDLES (OPTIONAL) WARNING WARNING Proper inflation extends the life of your tires and makes When you have an attendant, make sure that this chair your chair easier to use.
A L L C O U R T VIII. W RNINGS: COMPONENTS & OPTIONS M. MODIFIED SEAT SYSTEMS WARNING Use of a seat system not approved by Sunrise may alter the center of balance of this chair. This may cause the chair to tip over.
A L L C O U R T IX. SET-UP DJUSTMENT IX. SET-UP AND ADJUSTMENT A. SET-UP Setting the wheelchair on a table or flat surface, such as a workbench or table, helps make these procedures easier. Torque Settings: A torque setting is the optimum tightening which should be made on a particular fastener.
A L L C O U R T IX. SET-UP DJUSTMENT D. BACKREST (FIXED OR FOLDING) 1. Backrest Installation To install backrest, remove the nut, plastic saddle and bolt from the backrest tube. Place the backrest in the upright position and reinstall in the lower plate hole (A). Backrest bolts should be tightened to 65 in-lbs.
Page 15
A L L C O U R T IX. SET-UP DJUSTMENT FOLDING BACK– ZERO OFFSET (FIG. A) 1. Remove screw (2), nut (3), eccentric washer (4) and offset plastic saddle (5) from backplate / back rest assembly. 2. Aluminum– Swap the 1-3/4" long screw (2) for a 1-7/8" long screw (2A) and the "offset"...
Page 16
A L L C O U R T IX. SET-UP DJUSTMENT FIXED BACK– ZERO OFFSET (FIG. C) 1. Remove screws (2 & 2C), nuts (3) and eccentric washer (4) from backplate / backrest assembly. 2. Aluminum– Swap the 1-3/4" long screw (2) for a 1-7/8" long screw (2A), and the two 1-7/8"...
H. REAR AXLE ASSEMBLY 1. Center of Gravity Adjustment The most important adjustment on your Quickie All Court is the position of your center of gravity. The position of your seat frame will determine your center of gravity. • The further forward the seat, the more stable the chair becomes.
A L L C O U R T IX. SET-UP DJUSTMENT I. CASTER FORKS Caster Wheel Replacement a. Loosen the bolt and remove the caster wheel and the two washers. b. Position new caster wheel into fork. c. Carefully position washer on each side of caster wheel. d.
2. Review troubleshooting guide. 3. If your problem persists, contact your authorized Quickie supplier. If you still have a problem after contacting your authorized Quickie supplier, contact Sunrise Medical customer service. See the introduction page for details on how to contact your author- ized Quickie supplier or Sunrise Medical customer service.
A L L C O U R T X. TROUBLESHOOTING X. TROUBLESHOOTING You will need to adjust your chair from time to time for best performance (especially if you alter the original settings). This chart gives you a first solution, then a second and a third if needed.
A L L C O U R T XII. M INTEN NCE C. MAINTENANCE TIPS XI. MAINTENANCE 1. Axles & Axle Sleeves: A. INTRODUCTION Check axles and axle sleeves every six months to make sure they are tight. Loose sleeves will damage the axle plate and will affect 1.
A. FOR TWO (2) YEARS E. WHAT YOU MUST DO Sunrise Medical warrants the frame and quick-release axles of this 1. Obtain from us, while this warranty is in effect, prior wheelchair against defects in materials and workmanship for two approval for return (2) years from the date of first consumer purchase.