5
6.5 MECHANISM ADJUSTMENT
Tangential and Radial Height Coarse Adjustment
1
START
• Remove the pickup Assy from the Traverse Mecha. Assy.
• Remove the joint and the joint spring of the pickup Assy.
Note:
Before removing the flexible cable for the
pickup, soldering of the pickup circuit is
necessary.
For details, see "7.1.10 DISASSEMBLY".
• Pass through the guide shaft to a new pickup Assy-S.
• Attach it to the Traverse Mecha. Assy.
• Put the joint between the Tangential (or Radial) adjustment screw and the Mechanism Base
and turn each screw to adjust the height.
(Refer to "6.1 ADJUSTMENT ITEMS AND LOCATION".)
• Attach the Traverse Mecha. Assy to the Loader Assy.
• Turn it over and attach the joint and the joint spring.
• Arrange the flexible cables.
(Refer to "7.1.10 DISASSEMBLY".)
5
6
Guide Shaft
DV-373-S
6
7
Pickup Assy
Joint
Joint Spring
Pickup Assy-S
Joint
7.5mm
Mechanism Base
7
8
A
B
C
D
E
F
47
8