Table of Contents
Advertisement
10
10
Finishing
A. Facing Material
• Metal front faces may be covered with non-combustible
materials only.
• Facing and/or fi nishing materials must not interfere with
air fl ow through louvers, operation of louvers or doors,
or access for service.
• Facing and/or fi nishing materials must never overhang
into the glass opening.
• Observe all clearances when applying combustible
materials.
Note: If using the optional fi nishing trim for the Modern Front
facing, fi nish wall material must not be installed within 3 in.
(76 mm) of the fi replace opening. See Figure 14.5.
• Seal joints between the fi nished wall and appliance top
and sides using a 300 ºF minimum sealant. Refer to
Figure 10.1.
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specifi ed in
this manual. Overlapping materials could ignite and will
interfere with proper operation of doors and louvers.
NOTICE: Surface temperatures around the appliance will
become warm while the appliance is in operation. Ensure
finishing materials used for all surfaces (floor, walls,
mantels, etc.) will withstand temperatures up to 190°F.
42.25 in. (NEVO3630)
48.25 in. (NEVO4236)
30.22 in.
6 in.
Figure 10.1 Marble/Granite Cut Dimensions
1/8 in. reveal
all sides
6 in.
Heatilator • NEVO3630I-B, NEVO4236I-B Installation Manual • 2378-980 Rev. E • 4/16
•
Figure 10.1 shows the dimensions for cutting marble/
granite if the optional Finishing Trim is not used.
•
The dimensions given assume a 1/8 in. reveal around
the fi replace opening.
Finish wall material may be
combustible - Top and Sides
0 in.
High Temperature Sealant (300° F/149° C min.)
Top and Side Seal Joint
Figure 10.2 Non-combustible Facing Diagram
3 in. (76 mm)
Gray shading represents
clearance needed for optional
Finishing Trim that may be used
with the Modern Front. No facing
material may be used within the
shaded area.
Note: Fireplace MUST be elevated 1
1/2 in. (38 mm) off fl oor
Figure 10.3 Clearance for Optional FInishing Trim (Modern Front)
0 in.
0 in.
3 in.
(76 mm)
3 in.
(76 mm)
45
Advertisement
Table of Contents
