Rear Vent
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
•
Fold the tabs toward the center of the vent cap (90º) and
remove the insulation gasket.
Figure 6.7
•
Cut the metal retaining band and fold the sides out.
Figure 6.8
•
Fold the center parts of the retaining band out and use
to remove the vent cap.
Figure 6.9
Heatilator • NEVO3630I-B, NEVO4236I-B Installation Manual • 2378-980 Rev. E • 4/16
•
Discard the vent cap, remove and discard the insulation
basket.
Figure 6.10
•
Attach the fi rst vent section (it will snap into place). Slide
the insulation gasket onto the vent section, up against
the appliance and over the tabs.
Figure 6.11
31