Wiring Requirements - Heatilator NEVO3630I-B Installation Manual

B. Wiring Requirements
Intellifi re Plus Ignition System Wiring
TM
• Wire the appliance junction box to 110-120 VAC for
proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction box to a switched circuit.
Incorrect wiring will override IPI safety lockout.
• Refer to Figure 8.2, IPI Wiring Diagram.
• This appliance is equipped with an IntelliFire™ Plus
control valve which operates on a 6 volt/1.5 AMP system.
• Plug the 6 volt transformer plug into the appliance junction
box to supply power to the unit OR install 4 AA cell
batteries (not included) into the battery pack before use.
NOTICE: Batteries should only be used as a power source
in the event of an emergency power outage. Batteries
should not be used as a primary long-term power source.
Battery polarity must be correct when installing batteries.
Do not store batteries in the battery pack when the
appliance is powered by the 6 volt transformer connected
to permanent electrical service.
Power supply
plugged into
junction box
Valve
Figure 8.2 IntelliFire™ Plus Intermittent Pilot Ignition (IPI) Wiring Diagram
Module
Wiring
harness
BLK
Heatilator • NEVO3630I-B, NEVO4236I-B Installation Manual • 2378-980 Rev. E • 4/16
Pilot
assembly
ORG
WHT
Battery
holder
BLK
RED
Wall
switch
wires
RC100 (optional)
RC200 (optional)
RC300 (optional)
41