Table of Contents
Advertisement
Coaxial (good)
On your TV
Coaxial cable
connector
ANT/CABLE IN
jack
1 Make sure that your TV's power cord is unplugged and all connected equipment is turned off.
2 Connect the incoming cable from the cable wall jack to the cable-in jack on the cable or satellite box.
3 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the back of your TV and to the coaxial out jack
on the cable or satellite box.
4 Plug your TV's power cord into a power outlet, turn on your TV, then turn on the cable or satellite box.
5 Press INPUT to open the Input Selection list.
6 Press
or
to highlight ANT/Cable, then press ENTER.
7 If you cannot tune to channels you know exist, scan for channels. See
page 54.
Notes
18
U.S.: http://support.toshiba.com Canada: http://support.toshiba.ca/support/ceg/
Cable or
satellite box
Coaxial cable
Cable
wall jack
• Use a coaxial cable to eliminate interference and noise from radio
waves.
• Do not bundle the coaxial cable with the power cord or other cables.
Toshiba 40" 1080p 60Hz LED TV
Back of TV
Automatically scanning for channels
on
Hide quick links:
Advertisement
Table of Contents
