Wired Remote Control - Daikin FH35GZ Technical Data Manual

8 Control systems
8-1

Wired remote control

NAME AND FUNCTION OF EACH SWITCH AND
DISPLAY ON THE REMOTE CONTROL (Fig.1)
ON/OFF BUTTON
1
Press the button and the system will start. Press the button again and
the system will stop.
OPERATION LAMP (RED)
2
The lamp lights up during operation.
DISPLAY ' h ' (UNDER CENTRALISED CONTROL)
3
When this display shows, the system is UNDER CENTRALISED
CONTROL. (This is not a standard specification).
DISPLAY '
4
This display shows when the outdoor unit is individual operation
system.
DISPLAY ' n ' (VENTILATION/AIR CLEANING)
10
5
This display shows that the total heat exchange unit and the air
8 cleaning unit are in operation. These are optional accessories.
DISPLAY ' A ' ' I ' ' , ' ' u ' ' w ' (OPERATION MODE)
8-1
6
This display shows the current OPERATION MODE. For cooling only
type, ' , ' (Auto) and ' w ' (Heating) are not installed.
DISPLAY ' b ' (INSPECTION/TEST OPERATION)
7
When the INSPECTION/TEST OPERATION BUTTON is pressed, the
display shows the system mode is in.
DISPLAY 'I' (PROGRAMMED TIME)
8
This display shows PROGRAMMED TIME of the system start or stop.
DISPLAY ' O ' (SET TEMPERATURE)
9
This display shows the set temperature.
DISPLAY ' B C '(FAN SPEED)
10
The display shows the set fan speed.
DISPLAY ' a ' (AIR FLOW FLAP)
11
DISPLAY ' ; ' (TIME TO CLEAN AIR FILTER)
12
22
• Ceiling Suspended Unit • R-407C • FH(Y)-GZ/BZ/FHYP-B
' (CHANGEOVER UNDER CONTROL)
• Split - Sky Air • Indoor Units
13
DISPLAY 'f' (DEFROST)
14
TIMER MODE START/STOP BUTTON
15
TIMER ON/OFF BUTTON
INSPECTION/TEST OPERATION BUTTON
16
This button is used only by qualified service persons for maintenance
purposes.
PROGRAMMING TIME BUTTON
17
Use this button for programming 'START and/or STOP' time.
(Operates with the front cover of the remote control)
TEMPERATURE SETTING BUTTON
18
Use this button for SETTING TEMPERATURE.
19
FILTER SIGN RESET BUTTON
FAN SPEED CONTROL BUTTON
20
Press this button to select the fan speed, HIGH or LOW, of your
choice.
OPERATION MODE SELECTOR BUTTON
21
Press this button to select OPERATION MODE.
22
AIR FLOW DIRECTION ADJUST BUTTON
(NOTE)
+ For the sake of explanation, all indications are shown on the
display in Figure 3 & 4 contrary to actual running situations.