Connecting The Fm/Am Antennas; Connecting The Power Cable - Yamaha RX-V381 Owner's Manual

4

Connecting the FM/AM antennas

Connect the supplied FM/AM antennas to the unit.
Fix the end of the FM antenna to a wall, and place the AM antenna on a flat surface.
FM antenna
AM antenna
The unit (rear)
Assembling and connecting the AM antenna
Hold down
Note
▪ Unwind only the length of cable needed from the AM antenna unit.
▪ The wires of the AM antenna have no polarity.
Insert Release
5

Connecting the power cable

Warning
(Taiwan, Brazil and General models only)
Make sure you set VOLTAGE SELECTOR of the unit BEFORE plugging the power cable into an AC wall
outlet. Improper setting of VOLTAGE SELECTOR may cause damage to the unit and create a potential
fire hazard.
Before connecting the power cable
Set the switch position of VOLTAGE SELECTOR according to your local voltage. Voltages are AC 110–
120/220–240 V, 50/60 Hz.
The unit (rear) VOLTAGE SELECTOR
After all the connections are complete, plug in the power cable.
The unit (rear)
23
En
VOLTAGE
SELECTOR
110V–
120V
220V–
240V
To an AC wall outlet