Listening To Fm/Am Radio; Setting The Frequency Steps; Selecting A Frequency For Reception - Yamaha RX-V381 Owner's Manual

Listening to FM/AM radio

You can tune into a radio station by specifying its frequency or selecting from
registered radio stations.
Note
▪ The radio frequencies differ depending on the country or region where the unit is being used. The
explanation of this section uses a display with frequencies used in U.K. and Europe models.
▪ If you cannot obtain good reception on the radio, adjust the direction of the FM/AM antennas.

Setting the frequency steps

(Asia, Taiwan, Brazil and General models only)
At the factory, the frequency step setting is set to 50 kHz for FM and 9 kHz for AM.
Depending on your country or region, set the frequency steps to 100 kHz for FM and
10 kHz for AM.
1
Set the unit to standby mode.
2
When holding down STRAIGHT on the front panel, press z
(power).
z (power)
PROGRAM STRAIGHT
3
Press PROGRAM repeatedly to select "TU".
CHARGE ENHANCER STEREO TUNED
OUT
ECO
TU••••FM50/AM9
SLEEP MUTE
VOL.
ADAPTIVE DRC VIRTUAL
4
Press STRAIGHT to select "FM100/AM10".
5
Press z (power) to set the unit to standby mode and turn it on
again.

Selecting a frequency for reception

1
Press FM/AM to select a band.
"TUNER" is selected as the input source and then the frequency currently
selected is displayed.
CHARGE ENHANCER STEREO TUNED
OUT
ECO
FM 87.50MHz
37
En
SLEEP MUTE
VOL.
ADAPTIVE DRC VIRTUAL